straw briquette pellet

the main raw material is straw, corn, etc.
1. The pinch roller of the machine is taper, it can make the speed of two tops and the speed of inner and outer of die in the same, so that the roller and die wont be malposition friction, the resistance is reduced, the loss of kinetic energy is lower, the useful time of die is extended.
2. The machine adopted screw center pressure regulating device, the die clearance can be bigger or smaller, applicable to different materials, so that the effect of suppress could be guarantee.
3. The body of machine is big, the slotware is more wide, so that this machine is bearing pressure and hard wearing. The pinch roller is the center part in the system. Feed cone can be increased on freewill, these advantages cannot rich by other machine:
Advantage I: After largening the pinch roller, the bearing were largened, the ability of under pressure were strengthened.
Advantage II: After largening the pinch roller, the heat coming from pinching and friction is hard be transport to bearing housing, so that lubricant grease wont overflow, when the bearing work in low temperature.
Advantage III: After largening the pinch roller, the pinch roller could be repaired 2 or 3 times, it extends the useful time, so that the cost of production is bringing down., and increasing the profit margin.
4. The pinch roller adopt several uniform distributions, so it works smoothly, at the same time, it adds suppress area to increase the productivity effect.
5. Φ20--Φ30mm20×30mm(1.5-Φ15mm),,.
The Compression Molding Pressing are diversification, round barΦ20--Φ30mmdiamonds20×30mm, kernel(1.5-Φ15mm),
6. There is a observation door in the room of briquette, it is convenient for keeping a good repair.